Ask a Winter Haven homeowner what bothers them about their air conditioner and plenty will not say the house is hot. They will say it feels damp. Living inside a chain of roughly fifty connected lakes puts an enormous amount of moisture in the air, and pulling that moisture out is half of what your system is supposed to do. Egberts Electric and Air Conditioning repairs cooling systems throughout Winter Haven with exactly that in mind.
Getting the temperature down is the straightforward part. Getting the moisture out takes a system that runs long enough and moves air at the right speed, and that is where a lot of Winter Haven homes come up short.
Our diagnostic covers refrigerant charge, electrical components, blower speed, thermostat operation, and the condensate system, and we look at cycle length as part of the picture. A system that satisfies the thermostat in eight minutes never gets around to dehumidifying anything.
We repair split systems, heat pumps, and package units, and we carry commonly failed parts so most visits end with the equipment running. When the fix turns out to be an adjustment rather than a part, that is what we do.
Watch for these, especially the ones about moisture.
Any moisture symptom deserves a call, since sustained indoor humidity leads to problems well beyond comfort.
Moisture removal only happens while the system is actually running. Air passes over a cold evaporator coil, water condenses out of it, and that water drains away. Cut the runtime short and the air gets cooled without getting dried, which is exactly the sensation people here describe as cold and sticky.
Oversized equipment is usually the culprit. A unit with more capacity than the house needs hits the thermostat setting fast, shuts down, and repeats, never running long enough to pull real moisture out. It is a common outcome when equipment gets replaced by matching an old label instead of measuring the house.
The geography then guarantees the problem shows up. With canals connecting lake after lake across the city, outdoor humidity stays elevated day and night, and homes near the water take on moisture through every door opening and small air leak. Add drain lines that clog quickly in that environment and comfort suffers long before anything actually breaks.
Marta called from Cypresswood one evening because her house felt damp even with the thermostat holding at seventy two. Everything looked and sounded like it was working properly.
Our technician watched the system cycle and found it running only a few minutes at a time, with blower speed set higher than the equipment needed. He adjusted the blower speed, cleaned a partially blocked drain line, and checked the refrigerant charge to rule out anything else contributing.
The cycles lengthened, the coil finally had time to do its job, and the house felt noticeably drier by the next day. Nothing had failed, but the setup had been working against her the entire time.
Here is what comes with every service call in this city.
Cooling is only part of the job, and we take the other part just as seriously.
The system is likely cooling faster than it dehumidifies, often because it is oversized or the blower moves air too quickly. Both are fixable.
Yes. Oversized equipment short cycles, which leaves moisture in the air and adds unnecessary wear to the components.
Somewhere between forty five and fifty five percent keeps most homes comfortable and discourages mold growth.
It can help, though it is better to first find out why the system is not removing moisture on its own.
Yes. Emergency service is available to Winter Haven homeowners, including nights, weekends, and holidays.
